Important Note:
We suggest you use this AIO on your 3.5″ to 5″ cinewhoops/long-range or lightweight quads. For quads below 3.5″,
you should carefully check if your quad has enough room for this AIO.
Overview | |
Product Name | SpeedyBee F745 35A BLS AIO |
Power Input | 3S – 6S Lipo |
Mounting | 25.5 x 25.5mm, 3mm hole diameter |
Dimension | 36.5mm(L) x 36.5mm(W) x 7mm(H), recommended for quads at 3.5″ or above |
Weight | 10.1g |
FC | |
MCU | STM32F745 |
IMU(Gyro) | MPU6000 |
USB Connection | Need to solder a USB TYPE-C module to D+,D-, and GND pads. |
Barometer | BMP280 |
OSD | Supported |
BLE Bluetooth | Supported. Used for parameter configuration, built-in a single 2.4 GHz Wi-Fi-and-Bluetooth combo chip |
Flash FC Firmware Wirelessly | Supported |
Download/Analyze Blackbox | Supported |
DJI Air Unit 6-pin Connector | Built-in. |
Flash(for BlackBox) | 8MB |
Current Sensor | Supported. Scale=256 |
BetaFlight Camera Control Pad | Yes(CC pad) |
5V Output | 4 groups of 5V output. The total current load is 2.5A. |
9V Output | None |
ESC Signal Pads | M1 – M4 |
UART | Full UART * 4(UART1, UART2, UART3,UART4) |
ESC Telemetry UART | None |
I2C | Supported. |
LED Pad | Used for WS2812 LED |
Buzzer | BZ+ and BZ- pad used for 5V Buzzer |
BOOT Button | Used to enter DFU mode |
RSSI Input | Not supported |
SmartPort | Not Supported |
Supported Flight Controller | BetaFlight(Default) |
Firmware Target Name | SPEEDYBEE F745AIO |
ESC | |
Power Input | 3-6S LiPo |
Continuous Current | 35A * 4 |
Burst Current | 45A(5seconds) |
ESC Protocol | DSHOT300/600 |
Power Output | VBAT |
Current Sensor | Supported(Sacle=256) |
Firmware | BLHeli_S JH40 |
Reviews
There are no reviews yet.